Simple demonstrative proof of Electrogravitic Thrust Vector as observed by
1. MATERIALS REQUIRED:
(a) Plexiglas Vacuum Chamber 18" x 18" x 18"
(b) Vacuum Gage
(c) 1 Pc. 1/8" x 12" x 12" Acrylic Plexiglas
(d) Two Sheets 6" x 6" Aluminum Foil
(e) 6' Carpenter's Nylon Twine
(f) 50 ft. AWG #32-26 Magnet Wire
(g) Vacuum Pump (10-6 mm Hg. capability)
(h) 50-250 KV DC Ion Generator.
2. PROCEDURE:
Construct the configuration shown in Figure 3
(b) Tightly coil exactly the same length of wire (f) around a thin (1/4’’) rod to form two equal weight coiled coils.
(c) Use epoxy to attach (f) to (d) and through (a) making sure good electrical contact with (d) is obtained, and a pressure tight seal through (a) is obtained.
(d) Plate (c) should freely swing as shown.
(e) Evacuate the chamber to 10-6 mm Hg.
(f) Turn on the High-Voltage supply.
(g) Observe the thrust in the positive direction.
3. OBSERVATIONS
(a) Note that the thrust caused is not ion wind, as you are at 10-6mmHg. vacuum
(b) Note further, that as the plate (c) is substituted for by dielectrics of varying mass, the greater the mass, the greater the observed thrust!
4. CONCLUSIONS
The thrust caused is due to a yet "unknown" or non-defined scientifically
force (electrogravitic?).